Canon imagePROGRAF iPF8000S User Manual page 763
Hide thumbs
Also See for imagePROGRAF iPF8000S:
- Service manual (334 pages) ,
- Questions and answers (36 pages) ,
- Brochure (8 pages)
Table of Contents
Advertisement
To protect the internal parts in transit, always follow the steps below before transferring the printer to a new
location. Refer to the Quick Start Guide for details on packing the printer and installing it after transfer.
Caution
•
Avoid tipping the printer excessively in transit. Ink inside the printer may leak and cause stains. If it is
necessary to stand the printer up or tilt it, contact your Canon dealer.
1.
Remove the paper.
•
Roll
(→P.128)
(→P.129)
(→P.130)
•
Sheet
(→P.152)
2.
Press the Menu button to display MAIN MENU.
3.
Press ▲ or ▼ to select Maintenance, and then press the ► button.
4.
Press ▲ or ▼ to select Move Printer, and then press the ► button.
5.
Press ▲ or ▼ to select the level of transfer, and then press the OK button.
The printer now starts preparing for transfer.
Under Level 1 conditions, follow the procedure starting with step 12. There is no need to remove
Ink Tank.
When you are nished preparing to transfer the printer under Level 2 or Level 3 conditions, the
Display Screen prompts you to open the Ink Tank Cover. You must remove the Ink Tank at this
point. Follow the procedure starting with step 6.
6.
Open the left and right Ink Tank Covers.
Other Maintenance
Maintenance 747
- Quick Links:
- Print Area
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the imagePROGRAF iPF8000S and is the answer not in the manual?
Questions and answers
how so you get to initialize on canon program Ipf8000s
To initialize the Canon imagePROGRAF iPF8000S, you can configure its IP address using the imagePROGRAF Device Setup Utility by following these steps:
1. Start the imagePROGRAF Device Setup Utility from the Start menu.
2. Select the printer from the Device Name list.
3. Choose "Protocol Settings" from the Printer menu.
4. In the "Setting IP Address" list, select "Manual".
5. Enter the assigned IP address and click the "Set" button.
6. Click "OK" when the confirmation message appears.
7. Exit the utility.
Alternatively, to configure the IP address automatically, choose "Auto" and select DHCP, BOOTP, or RARP. You can also set the subnet mask and default gateway.
This answer is automatically generated