Select�Ng The Paper Type (Roll) - Canon imagePROGRAF iPF8000S User Manual
Hide thumbs
Also See for imagePROGRAF iPF8000S:
- Service manual (334 pages) ,
- Questions and answers (36 pages) ,
- Brochure (8 pages)
Table of Contents
Advertisement
Choosing Paper for Printing
Selecting the Paper Type (Roll)
When changing the type of paper after the paper has been advanced, specify the type of paper as follows.
Important
•
For best printing results, the printer ne-tunes the feed amount for each type of paper. Be sure to select
the type of paper to use correctly before printing.
•
Because the printer ne-tunes the feed amount for each type of paper, the margins and the size of
printed images may vary depending on the type of paper used. If margins and the size of images are not
as you expected, adjust the paper feed amount and Printhead height.
(→P.683)
(→P.682)
Note
•
After you load the roll, the printer automatically shows a menu for selection of the paper type on the
Display Screen, unless a barcode has been printed on the roll or you have activated automatic detection
of the remaining roll paper. Select the type of paper, and then press the OK button.
If no barcode has been printed on the roll and you have activated automatic detection of the remaining
roll paper, specify the roll length after the paper type. (→P.126)
1.
Press the Menu button to display MAIN MENU.
2.
Press ▲ or ▼ to select Media Menu, and then press the ► button.
3.
Press ▲ or ▼ to select Roll Media Type, and then press the ► button.
4.
Press ▲ or ▼ to select the type of paper loaded in the printer, and then press the OK button.
Note
•
For details on types of paper, see the Paper Reference Guide. (→P.109)By factory default, Plain
Paper is selected.
•
If you move the Release Lever, the setting automatically reverts to the previously selected paper.
•
Be sure to select the correct paper type. If this setting does not match the loaded paper, it may
cause feed errors and affect the printing quality.
•
If you select a type of paper for which width detection is Off when detection of the remaining roll paper
is also Off, you will need to advance the paper manually to the starting position for printing. (→P.127)
5.
Press the Online button to bring the printer online.
262 Enhanced Printing Options
- Quick Links:
- Print Area
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the imagePROGRAF iPF8000S and is the answer not in the manual?
Questions and answers
how so you get to initialize on canon program Ipf8000s
To initialize the Canon imagePROGRAF iPF8000S, you can configure its IP address using the imagePROGRAF Device Setup Utility by following these steps:
1. Start the imagePROGRAF Device Setup Utility from the Start menu.
2. Select the printer from the Device Name list.
3. Choose "Protocol Settings" from the Printer menu.
4. In the "Setting IP Address" list, select "Manual".
5. Enter the assigned IP address and click the "Set" button.
6. Click "OK" when the confirmation message appears.
7. Exit the utility.
Alternatively, to configure the IP address automatically, choose "Auto" and select DHCP, BOOTP, or RARP. You can also set the subnet mask and default gateway.
This answer is automatically generated