Canon imagePROGRAF iPF8000S User Manual page 335
Hide thumbs
Also See for imagePROGRAF iPF8000S:
- Service manual (334 pages) ,
- Questions and answers (36 pages) ,
- Brochure (8 pages)
Table of Contents
Advertisement
Borderless Printing at Actual Size (Mac OS 9)
This topic describes how to print borderlessly at actual size based on the following example.
•
Document: Any type
•
Page size: 10 × 12 inches (254.0×304.8 mm)-Borderless
•
Paper: Roll
•
Paper type: Heavyweight Coated Paper
•
Roll width: 10 inches (254.0 mm)
1.
Select the printer in Chooser.
2.
Choose Page Setup from the application menu to display the Page Attribute dialog box.
3.
D
In
Print Area Setting, click
4.
A
In the
Page Size list, choose a paper size supported for borderless printing. Here, click
10"x12" - Borderless.
Note
•
Paper sizes supported for borderless printing are indicated by "-Borderless."
5.
I
Click
OK to close the dialog box.
6.
In the application, create an original that takes up the entire space of the paper size.
7.
Choose Print in the application menu.
8.
Make sure the Main pane is displayed.
H
For Broderless Printing.
Printing at full size
Enhanced Printing Options 319
- Quick Links:
- Print Area
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the imagePROGRAF iPF8000S and is the answer not in the manual?
Questions and answers
how so you get to initialize on canon program Ipf8000s
To initialize the Canon imagePROGRAF iPF8000S, you can configure its IP address using the imagePROGRAF Device Setup Utility by following these steps:
1. Start the imagePROGRAF Device Setup Utility from the Start menu.
2. Select the printer from the Device Name list.
3. Choose "Protocol Settings" from the Printer menu.
4. In the "Setting IP Address" list, select "Manual".
5. Enter the assigned IP address and click the "Set" button.
6. Click "OK" when the confirmation message appears.
7. Exit the utility.
Alternatively, to configure the IP address automatically, choose "Auto" and select DHCP, BOOTP, or RARP. You can also set the subnet mask and default gateway.
This answer is automatically generated