Canon imagePROGRAF iPF8000S User Manual page 426
Hide thumbs
Also See for imagePROGRAF iPF8000S:
- Service manual (334 pages) ,
- Questions and answers (36 pages) ,
- Brochure (8 pages)
Table of Contents
Advertisement
Centering originals
Printing Originals Centered on Sheets (Windows)
This topic describes how to reduce an original 50% for printing centered on a sheet.
•
Document: Any Type
•
Page size: A4 (210.0 × 297.0 mm)/Letter (8.3 × 11.7 in)
•
Paper: Sheets
•
Paper type: Plain Paper
•
Paper size: A4 (210.0 × 297.0 mm)/Letter (8.3 × 11.7 in)
1.
Choose Print in the application menu.
2.
Select the printer in the dialog box, and then open the printer driver dialog box. (→P.482)
3.
Make sure the Main sheet is displayed.
4.
A
In the
Media Type list, select the type of paper that is loaded. In this case, click Plain Paper.
5.
Select the printing application in the
6.
Click the Page Setup tab to display the Page Setup sheet.
7.
A
In the
Page Size list, click the size of the original as specied in the application. In this case,
click ISO A4 or Letter (8.5"x11").
8.
Select the
410 Enhanced Printing Options
C
Enlarged/Reduced Printing check box.
E
Print Target list.
- Quick Links:
- Print Area
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the imagePROGRAF iPF8000S and is the answer not in the manual?
Questions and answers
how so you get to initialize on canon program Ipf8000s
To initialize the Canon imagePROGRAF iPF8000S, you can configure its IP address using the imagePROGRAF Device Setup Utility by following these steps:
1. Start the imagePROGRAF Device Setup Utility from the Start menu.
2. Select the printer from the Device Name list.
3. Choose "Protocol Settings" from the Printer menu.
4. In the "Setting IP Address" list, select "Manual".
5. Enter the assigned IP address and click the "Set" button.
6. Click "OK" when the confirmation message appears.
7. Exit the utility.
Alternatively, to configure the IP address automatically, choose "Auto" and select DHCP, BOOTP, or RARP. You can also set the subnet mask and default gateway.
This answer is automatically generated