Canon imagePROGRAF iPF8000S User Manual page 387
Hide thumbs
Also See for imagePROGRAF iPF8000S:
- Service manual (334 pages) ,
- Questions and answers (36 pages) ,
- Brochure (8 pages)
Table of Contents
Advertisement
Printing on Non-Standard Paper Sizes (Mac OS 9)
This section describes how to print using Custom Paper Size based on the following example. Here, you will
register a non-standard paper size named "430*430" in Custom Paper Size. Document:
•
Document: Scanned image
•
Page size: A square sheet (430 × 430 mm [16.9 × 16.9 in])
•
Paper: Sheets
•
Paper type: Plain Paper
•
Paper size: A square sheet (430 × 430 mm [16.9 × 16.9 in])
1.
Create the document in the application.
2.
Load the square paper (430 × 430 mm [16.9 × 16.9 in]) in the printer.
3.
Select the printer in Chooser.
4.
Choose Page Setup from the application menu to display the Page Attribute dialog box.
5.
Click Media Design in the Page Attribute list to display the Media Design pane.
6.
Enter a paper name of your choice in
7.
F
In
Media Size, enter the height and width of the original. Here, enter "430" in
Wid..
8.
J
Click
Add to add the paper size named "430*430".
Printing banners or at other non-standard sizes
B
Custom Name. "430*430" is used in this example.
H
G
Hght and
Enhanced Printing Options 371
- Quick Links:
- Print Area
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the imagePROGRAF iPF8000S and is the answer not in the manual?
Questions and answers
how so you get to initialize on canon program Ipf8000s
To initialize the Canon imagePROGRAF iPF8000S, you can configure its IP address using the imagePROGRAF Device Setup Utility by following these steps:
1. Start the imagePROGRAF Device Setup Utility from the Start menu.
2. Select the printer from the Device Name list.
3. Choose "Protocol Settings" from the Printer menu.
4. In the "Setting IP Address" list, select "Manual".
5. Enter the assigned IP address and click the "Set" button.
6. Click "OK" when the confirmation message appears.
7. Exit the utility.
Alternatively, to configure the IP address automatically, choose "Auto" and select DHCP, BOOTP, or RARP. You can also set the subnet mask and default gateway.
This answer is automatically generated