Using The Output Stacker - Canon imagePROGRAF iPF8000S User Manual

Using the Output Stacker

The Output Stacker can be installed at four positions, as shown.
•
When storing printed documents on the Output Stacker
Use position (1).
•
When the Output Stacker is not used
Use position (2).
•
When the Media Take-up Unit is used, or when the Output Stacker is stored for long periods
Lower it to position (3) for storage. (→P.162)
When using the Output Stacker again after storage, reattach the Basket Rod on the front of the Output
Stacker to the tips of the left and right Basket Arms and pull the side rods out completely.
•
When printing on large, stiff sheets
Use position (3).
Set it to position (4) for large-format printing or when printing on delicate paper. (→P.159)
Important
•
When storing printed documents on the Output Stacker, always use it in position (1). If you do not, printed
documents may not be dropped into the Output Stacker, and the printed surface may become soiled.
•
The Output Stacker can hold one sheet. When printing multiple pages, remove each sheet after it
is printed.
•
Before using the Output Stacker, remove the Rewind Spool. If you do not, it may prevent printed
documents from being held correctly, and it they may be scratched.
•
The Output Stacker can hold printed documents from rolls that are 62 inches (1,575 mm) long. When
printing longer documents, eject them in front of the printer or use the optional Media Take-up Unit.
Output Stacker
Handling Paper 157