Removing The Printer Mechanism - Epson Stylus Photo R340 Service Manual

EPSON Stylus Photo R340/350

2.3.15 Removing the Printer Mechanism

Illustration (1)
C.B 3x6 (4-5kgf.cm)
2
1
C.B.P 3x8 (4-5kgf.cm) CD-R Paper Guide
Left Side of the Printer
2
Main Frame Screw (6-8kgf.cm)
Right Rear Side of the Printer
Upper Ink Eject
Porous Pad Support
Cable Tie
Figure 2-55. Removing the Printer Mechanism (1)
Disassembly and Assembly
C.B.S 3x6 (6-8kgf.cm)
C.B.P 3x8 (6-8kgf.cm)
4
3
C.B.P 3x8 (6-8kgf.cm)
1
Align the Edge of the Acetate
Right Front Side
Tape with the Bend Line.
of the Printer
Tray/CD-R Sensor
Acetate Tape
Connector Cable
Parts/Components must be removed to remove the Printer Mechanism.
Paper Support Assy., Left Housing, Right Housing,
Panel Board Assy. (Panel Board and LCD Module), Upper Housing,
Rear Housing, Main Board Assy., ASF Assy., Shaft Assy. Holder
Disassembly Procedure
5
1. Move the Carriage Unit to the center.
2. Remove the three screws (
it.
3. Remove the five screws (
4. Cut the cable tie and release the connector cables.
5. Remove the Upper Ink Eject Porous Pad Support from the Lower Housing.
6. Remove the two pieces of acetate tape and release the connector cable of the
Tray/CD-R Sensor.
3
Disassembly
Revision A
) that secure the CD-R Paper Guide and remove
) that secure the Printer Mechanism.
70