Epson Stylus Photo R340 Service Manual page 90

EPSON Stylus Photo R340/350
Reinstalling the Slider Lock Lever
Make sure that the Slider Lock Lever moves correctly
together with the Cap Slider.
Reinstalling the Ink System
Make sure that the Ink Tube is connected at the position
shown in the figure below. Improper connection of the tube
may cause ink leakage.
Figure 2-88. Ink Tube Connection Position
Check the green line printed on the Ink Tube to make sure
that the tube is not twisted.
Make sure that the Cap Assy. moves smoothly.
Make sure that the all gears are correctly set to the shaft of
the Pump Frame and move smoothly.
Make sure the Pump Assy. is correctly secured.
Make sure the Ink Tube is free of flattening or compression.
Disassembly and Assembly
Face the green line on the Ink Tube in the direction of the
arrow, and attach the tube to the two retainers ( ) on the
bottom of the Cap Frame in the order shown below.
The Green Line should
Face This Way
Reinstalling the Main Frame Support Plate
Set the four positioning holes ( ) of the Main Frame
Support Plate onto the guide pins.
Tighten the screws in the order shown below.
2
Positioning Holes
and Guide Pins
Figure 2-90. Reinstalling the Main Frame Support Plate
Disassembly
2
1
Figure 2-89. Reinstalling the Ink Tube
C.B.S 3x6
(7-9kgf.cm)
Revision A
1
90