EPSON Stylus Photo R340/350
2.3.6 Removing the Rear Housing
Illustration
C.B.P 3x8 (4-6kgf.cm)
Rear Cover
Hooked
Tabs
1
C.B.P 3x8 (4-6kgf.cm)
Figure 2-15. Removing the Rear Housing
Disassembly and Assembly
Rear Housing
Hooked
Tabs
2
C.B.S 3x8 (4-6kgf.cm)
Disassembly
Parts/Components must be removed to remove the Rear Housing.
Paper Support Assy., Left Housing, Right Housing,
Panel Board Assy. (Panel Board and LCD Module), Upper Housing
Disassembly Procedure
1.
Remove the screw (
) that secures the Rear Cover and remove it.
2.
Remove the two screws (
) that secure the Rear Housing.
3.
Slightly lift the Rear Housing to release it from the four tabs ( ), and remove
the Rear Housing.
Tighten the screws to secure the Rear Housing in the order
shown in
Figure
2-15.
Put the two tabs of the Rear Cover into the notches of the frame.
Figure 2-16. Reattaching the Rear Cover
Revision A
Tabs
Notches
50