Download Print this page

Advertisement

EPSON Stylus Photo R340/350
Occurrence
Timing
Symptoms
CR Position
• Occurrence
The PF Motor drive cannot be
Timing:
transmitted to the LD Roller Shaft.
During
operation
• CR Position:
---
The LD Roller Shaft cannot be set at the
ASF home position and paper is always
fed from the ASF Assy.
Troubleshooting
Table 1-7. Troubleshooting of Paper Out Error based on Observed Symptom (continued)
Failed Part
Shaft Assy. Holder 1. Check if the Extension Spring 0.143 in the clutch
2. Check if the Clutch is properly engaged with the LD
3. Check if the Clutch teeth are damaged.
4. Check if the Clutch is damaged.
Ink System
1. Check if the Compression Spring 2.36 in the Change
Ink System
1. Check if the tip of the Change Lever is damaged.
Check Point
mechanism has not come off.
Extension Spring 0.143
Clutch Teeth
Guide Pin on the LD Roller Shaft
Roller Shaft with the guide pin on the shaft.
Lever has not come off.
Change Lever
Compression
Spring 2.36
Troubleshooting
Revision A
Remedies
1. Attach the Extension Spring 0.143 to the
clutch mechanism properly.
2. Properly set the hole of the Clutch onto the
guide pin of the LD Roller Shaft.
3. Replace the Shaft Assy. Holder with a new
one.
4. Replace the Shaft Assy. Holder with a new
one.
1. Replace the Ink System with a new one.
1. Replace the Ink System with a new one.
20

Advertisement

Troubleshooting

   Related Manuals for Epson Stylus Photo R340

This manual also for:

Stylus photo 350

Comments to this Manuals

Symbols: 0
Latest comments: