Epson Stylus Photo R340 Service Manual page 86

EPSON Stylus Photo R340/350
Reinstalling the Tray Sensor Lever
Insert the Torsion Spring 2.8 onto the shaft of the Upper
CD-R Guide.
Pull the L-shaped leg of the Torsion Spring 2.8 with
tweezers in the direction shown in the figure below.
Set the positioning hole ( ) of the Tray Sensor Lever onto
the shaft of the Upper CD-R Guide, and hitch the L-shaped
leg of the Torsion Spring 2.8 to the position shown below.
Torsion Spring 2.8
Figure 2-82. Reinstalling the Tray Sensor Lever
Disassembly and Assembly
Tray Sensor Lever
Hitch the
Spring
Leg here
Disassembly
Reinstalling the CD-R Sensor Lever
Insert the Torsion Spring 4.26 onto the shaft of the Upper
CD-R Guide.
Set the positioning hole ( ) of the CD-R Sensor Lever onto
the shaft of the Upper CD-R Guide, and hitch the L-shaped
leg of the Torsion Spring 4.26 to the position shown below.
Torsion Spring 4.26
Figure 2-83. Reinstalling the CD-R Sensor Lever
Reinstalling the Lower CD-R Guide
Tighten the screws in the order shown in
Reinstalling the Upper CD-R Guide
Make sure that the two tabs of the Stacker Lock are
properly secured with a tension of the Compression Spring
5.1. See Figure 2-80.
After reinstalling the Lower CD-R Guide, make sure there
is no gap between the Lower and Upper CDR Guides.
Revision A
Hitch the Spring
CD-R Sensor
Leg here
Lever
Figure 2-80.
86