Download Print this page

Advertisement

EPSON Stylus Photo R340/350
5.
Move the Carriage Unit to the left edge of the printer, then set the Thickness
Gauge (1.30mm) on the left ribs (x3) of the Front Paper Guide.
Thickness Gauge
Figure 3-8. Setting Thickness Gauge
6.
Implement PG Adjustment on the left according to the flowchart in the
Start
Note:
Move the Carriage Unit to
the right by using the
Timing Belt.
Yes
Does the Thickness
Gauge move?
No
Take down the Left Parallel
Adjust Bushing toward the
printer front by 1 notch.
Take up: PG gets wider
Take down: PG gets narrower
Figure 3-9. PG Adjustment (Left Side)
Adjustment
Ribs
Figure
Take down toward the printer front by 1 notch:
PG gets narrower.
Take up toward the printer back by 1 notch:
PG gets wider.
Take up the Left Parallel
Adjust Bushing toward the
printer back by 1 notch.
Move the Carriage Unit to
the right by using the
Timing Belt.
Yes
Does the Thickness
Gauge move?
No
Go to
Step
7.
Adjustment Except Adjustment Program
7.
Remove the Thickness Gauge and move the Carriage Unit to the right edge. Then,
set the Thickness Gauge on the right ribs (x3) of the Front Paper Guide.
Ribs
Figure 3-10. Setting Thickness Gauge
3-9.
8.
Implement PG Adjustment on the right according to the flowchart in the
3-11.
Start
Move the Carriage Unit to
the left by using the
Timing Belt.
Does the Thickness
Gauge move?
No
Take down the Right Parallel
Adjust Bushing toward the
printer front by 1 notch.
Take down: PG
gets narrower
Figure 3-11. PG Adjustment (Right Side)
Thickness Gauge
Note:
Take down toward the printer front by 1 notch:
PG gets narrower.
Take up toward the printer back by 1 notch:
PG gets wider.
Yes
Take up the Right Parallel
Adjust Bushing toward the
printer back by 1 notch.
Move the Carriage Unit to
the left by using the
Take up:
Timing Belt.
PG gets wider
Does the Thickness
Gauge move?
No
Go to
Step
Revision A
Figure
Yes
9.
109

Advertisement

Troubleshooting

   Related Manuals for Epson Stylus Photo R340

This manual also for:

Stylus photo 350

Comments to this Manuals

Symbols: 0
Latest comments: