Epson Stylus Photo R340 Service Manual page 73

EPSON Stylus Photo R340/350
After making sure that the Waste Ink Tube is routed under the
Lower Waste In Pad, attach the Upper Ink Eject Porous Pad
Support to/in the position/orientation as shown in the figure
below making it contact with the Waste Ink Tube.
Right Rear Side of the Printer
Upper Ink Eject Porous Pad Support
Align the Edge of
the Pad with here
OK
Upside
Downside
Figure 2-60. Reattaching the Upper Ink Eject Porous Pad Support
Tie the following connector cables with a cable tie.
CR Motor (route the cable as shown in
PF Motor
PG Motor
Tray/CD-R Sensor
Power Supply Board
After tying the cables, cut the cable tie leaving a 20 mm-length
margin.
Tighten the screws to secure the Printer Mechanism and the
CD-R Paper Guide in the order shown in
Make sure that the Waste Ink Tube is free of flattening or
compression.
Make sure that the Cap Assy. moves smoothly.
Disassembly and Assembly
Lower Waste Ink Pad
NG
Figure 2-50.)
Figure 2-55.
Disassembly
Revision A
73