Epson Stylus Photo R340 Service Manual page 65

EPSON Stylus Photo R340/350
Reinstalling the LD Roller Shaft
Put the leg of the Torsion Spring 137.7 onto the cam of the
LD Roller Shaft to hold down the cam by the spring.
Cam
Figure 2-48. Setting the Torsion Spring 137.7
Reinstalling the Shaft Assy. Holder
Press down the left side of the Upper Paper Guide (when
viewed from the rear of the printer) to insert the PE Sensor
Lever into the notch. Be careful not to damage the PE
Sensor Lever.
Engage the Spur Gear 36.8 and the Combination Gear
27.2,19.2.
Combination Gear 27.2,19.2
Figure 2-49. Spur Gear 36.8 and Combination Gear 27.2,19.2
Set the ribs ( ) and tabs ( ) of the Shaft Assy. Holder into
the positioning holes of the Main Frame.
Tighten the screws to secure the Shaft Assy. Holder in the
order shown in
Disassembly and Assembly
Torsion Spring 137.7
See Figure 2-42.
Spur Gear 36.8
See Figure 2-42.
Figure 2-42.
Whenever the LD Roller Shaft is replaced, be sure to apply proper
A D J U S T M E N T
R E Q U I R E D
amount of the G-74 oil to the specified points. (See Chapter 4 for
details on the lubrication)
Disassembly
Revision A
65