Download Print this page

Advertisement

EPSON Stylus Photo R340/350
LCD Messages
External device is not connected or media
is not inserted. Backup canceled.
Insufficient space on the backup device.
Backup cannot be performed.
No memory card in slot. Backup canceled. Backup error (no card)
A printer error occurred. Please see your
manual.
Paper out. Load paper press the Start
button.
Paper or CD/DVD tray jam or feed error.
Press the Start button. If the error does not
clear, reinsert the paper or CD/DVD tray
and press the Start button.
Service required. Parts inside your printer
are at end of their service life. See your
manual for details.
Bluetooth print adapter cannot be
recognized. Please remove and reinstall
the adapter.
There is a problem with the IrDA
interface. See your manual.
The CD/DVD tray is not set correctly.
Reload the tray and press Start to
continue.
Troubleshooting
Table 1-3. LCD Error Messages and Possible Causes (continued)
Printer Condition
Backup error
Occurs in the following conditions:
(no external connection)
• An external device is not connected to the printer.
• No media is set into the connected external device.
• No image is stored on the memory card.
Backup error
The capacity of the media specified to back up is
(insufficient capacity)
insufficient.
No memory card is inserted into the slot of the printer.
Fatal error
Occurs in the following conditions:
• The Carriage Unit cannot move properly because of
an external force exerted on the unit.
• The PF Motor cannot operate properly.
No paper error
The PE Sensor could not detect the top edge of paper
during the paper feeding sequence.
Jam error
Occurs in the following conditions:
• The PE Sensor could not detect the bottom edge of
paper during the paper feeding operation.
• The Tray/CDR Sensor could not detect the bottom
edge of CD or DVD during the CD/DVD feeding
operation.
Maintenance error
This error is detected when the amount of the waste
liquid absorbed by the Waste Ink Pads has reached its
upper limit (when the protection counter has reached its
upper limit).
BT communications error
Had no response from the Bluetooth unit when the
printer started the Bluetooth communication.
IrDA communications error
Had no response from the IrDA unit when the printer
started the infrared data communication.
CDR error (correct set)
Occurs when the printer starts to print on a CD or DVD
without the CD/DVD tray attached.
CDR error (reset request)
The CD/DVD tray could not be detected properly when
the printer starts to print on a CD or DVD.
Warning/Error Messages and Possible Causes
Possible Causes
Automatically recovers from the error after a lapse
of three seconds.
Automatically recovers from the error after a lapse
of three seconds.
Automatically recovers from the error after a lapse
of three seconds.
Turn off the Power.
Press the Start button. The printer recovers from
the error when paper is fed correctly.
Remove the jammed paper or the CD/DVD tray.
Replace the Waste Ink Pads and reset the
Protector Counter.
Remove the Bluetooth unit and press the OK
button.
Remove the IrDA unit.
Automatically recovers from the error after a lapse
of three seconds.
Automatically recovers from the error after a lapse
of three seconds.
Revision A
Recovery from Errors
Reference
---
---
---
p.16
p.19
p.21
---
---
---
---
---
10

Advertisement

Troubleshooting

   Related Manuals for Epson Stylus Photo R340

This manual also for:

Stylus photo 350

Comments to this Manuals

Symbols: 0
Latest comments: