Be sure to first check the messages displayed on the LCD or the STM3 screen on a connected computer to identify the cause of the problem quickly. Then troubleshoot the problem
following the instructions given in the tables in this section. When any components to be repaired or replaced are found, see Chapter 2 "Disassembly/Reassembly" to correctly
reinstall or replace the components.
1.3.1 Troubleshooting by Error Message
Occurrence
Timing
Symptoms
CR Position
• Occurrence
The printer does not start up at all by
Timing:
turning the power On.
At power-on
• CR Position:
Anywhere
Troubleshooting
Table 1-4. Troubleshooting of Communication Errors based on Observed Symptom
Failed Part
Panel Board/
1. Check if the Panel FFC is correctly connected to CN1 on