Removing The Panel Board/Lcd Module - Epson Stylus Photo R340 Service Manual

EPSON Stylus Photo R340/350

2.3.4 Removing the Panel Board/LCD Module

Illustration (1)
Cosmetic Panel
Hooked Tabs
Connectors
Panel FFC
Panel Shield Plate
4
1
C.B.P 3x8 (4-6kgf.cm)
Figure 2-8. Removing the Panel Board/LCD Module (1)
Disassembly and Assembly
Hooked
Tab of the
Cosmetic
Panel
Hooked Tab
Attaching
Position on
the Panel
Board Assy.
Panel Board Assy.
Hooked Tabs
LCD FFC
Grooves Cable
2
3
Parts/Components must be removed to remove the Panel Board/LCD
Module.
None
Disassembly Procedure
1. Open the Printer Cover and Stacker Assy.
When performing the next step to remove the Cosmetic Panel, be
C A U T I O N
careful not to damage the two hooked tabs ( ) of the Cosmetic
Panel.
2. Push the two hooked tab attaching positions on the Panel Board Assy. with a
flat-blade screwdriver to release the two tabs ( ) of the Cosmetic Panel and
then release the upper right tab ( ).
3. Release the lower four tabs ( ) that secure the Cosmetic Panel and remove it.
When performing the next step, be careful not to pull the Panel
C A U T I O N
Board Assy. too much as it is still connected to the printer with the
FFC and the FFC is secured with two-sided tape.
4. Release the two tabs ( ) located at both ends of the Panel Board Assy. with a
flat-blade screwdriver and then release the two tabs ( ) to remove the Panel
Board Assy.
5. Disconnect the Panel FFC and the LCD FFC from the connectors.
6. Remove the four screws (
7. Release the Panel Shield Plate from the two grooves ( ) and remove the
panel pulling it out under the cable.
Disassembly
Revision A
) that secure the Panel Shield Plate.
46