Download Print this page

Advertisement

EPSON Stylus Photo R340/350
9.
After finishing PG Adjustment on the right, move the Carriage Unit to the left
edge again, then check PG according to the flowchart in the
Start
Note:
Move the Carriage Unit to
the right by using the
Timing Belt.
Yes
Does the Thickness
Gauge move?
No
Go to
Step 10
Take up: PG gets wider
Take down: PG gets narrower
Figure 3-12. PG Checking (1)
10. Move the Carriage Unit back to the left edge of the printer, then set the Thickness
Gauge (1.46mm) on the ribs (x3) of the Front Paper Guide in the same way as the
Figure
3-8.
Adjustment
Figure
3-12.
Take down toward the printer front by 1 notch:
PG gets narrower.
Take up toward the printer back by 1 notch:
PG gets wider.
Take up the Left Parallel
Adjust Bushing toward the
printer back by 1 notch.
Move the Carriage Unit to
the right by using the
Timing Belt.
Yes
Does the Thickness
Gauge move?
No
Go Back to
Step 7
Adjustment Except Adjustment Program
11. Check PGs on both the left and right according to the flowchart in the
Start
Check left PG.
Move the Carriage Unit to
the right by using the
Timing Belt.
No
Does the Thickness
Gauge move?
Yes
Check right PG.
Move the Carriage Unit to
the left by using the
Timing Belt.
No
Does the Thickness
Gauge move?
Yes
Go to
Step 12
Figure 3-13. PG Checking (2)
12. After finishing the adjustment, screw the Left (Right) Parallel Adjust Bushing.
13. After screwing, check PGs on both the left and right again according to the
flowchart in the
Figure
3-13.
Revision A
Figure
3-13.
Go Back to
Step 3
110

Advertisement

Troubleshooting

   Related Manuals for Epson Stylus Photo R340

This manual also for:

Stylus photo 350

Comments to this Manuals

Symbols: 0
Latest comments: