Epson Stylus Photo R340 Service Manual page 89

EPSON Stylus Photo R340/350
Illustration (2)
Combination Gear 27.2,19.2
Combination Gear
20.82,24
Spur Gear 27.2 Silicon Material
Ink Tube
Retainers
Slider Lock Lever
Slider Cap Porous Pad
Hooked
Tab
Push it up
Shaft
Figure 2-86. Removing the Ink System (2)
Disassembly and Assembly
Spur Gear 25.6 Change Lever
Guide Pins
Compression Spring 2.36
Cap Frame
Cap Slider
Hooked
Tabs
Extension
Spring 0.441
7. Remove the Combination Gear 20.82,24, Spur Gear 27.2, Change Lever
Assy., Combination Gear 27.2,19.2 from the Pump Assy.
8. Remove the Spur Gear 25.6 from the Change Lever.
9. Remove the Compression Spring 2.36 from the two guide pins ( ) of the
Change Lever.
10. Release the Ink Tube from the two retainers ( ) on the bottom of the Cap
Frame.
11. Remove the Extension Spring 0.441 from the tabs (
and the Cap Frame with tweezers.
12. Push the Cap Slider up to remove the shaft from the notch of the Cap Frame,
and remove the Slider Lock Lever.
13. Remove the Cap Slider Porous Pad from the tab ( ) of the Cap Slider with
tweezers.
Reinstalling the Cap Slider Porous Pad
Bend the Cap Slider Porous Pad along with the red line.
Insert the tab of the Cap Slider Porous Pad into the hole,
and set the two positioning holes of the pad onto the tab.
Slider Cap Porous Pad
Positioning Holes
Figure 2-87. Reattaching the Cap Slider Porous Pad
Disassembly
Revision A
) of the Cap Slider
Bend Line
Tab
Hooked Tab
Hole
89