Epson Stylus Photo R340 Service Manual page 53

EPSON Stylus Photo R340/350
Reattaching the Front Paper Guide Support Porous Pad
Bend the support porous pad along the bend line at a right
angle, and attach it to the Front Paper Guide. Make sure to
put the bent portion of the pads under the ribs and tightly
fit the pads onto the Front Paper Guide.
Reattaching the Front Paper Guide Porous Pad
Apply Three Bond 1401 to the six points on the Front Paper
Guide shown in the figure below. Immediately after
applying the bond, attach the Front Paper Guide Porous
Pad.
Left Side of the Printer
4 ± 1 mm Length
2 - 3 mm Width
Figure 2-21. Bond Applying Positions and Areas for Front Paper
After attaching the Front Paper Guide Porous Pad, draw a
mark on the left of the Front Paper Guide with a red pen.
Left Side of the Printer
Figure 2-22. Marking Point
Disassembly and Assembly
Right Side of the Printer
4 ± 1 mm Length 5 - 6 mm Width
1 - 2 mm Width
3 - 4 mm Width
Guide Porous Pad
Marking Point
Put the Front Paper Guide Porous Pad under the ribs and
be sure that the pad is tightly fitted on the Front Paper
Guide. Adjust the position of the Front Paper Guide Porous
Pad so that the gap between the pad and the Front Paper
Guide is 0.5 to 1.0 mm.
Figure 2-23. Reattaching the Front Paper Guide Porous Pad
Reattaching the Front Paper Guide Left Porous Pad
Put the protrusion of the Front Paper Guide Left Porous
Pad into the hole shown in
pad is tightly fitted on the Front Paper Guide.
Be careful not to damage the Front Paper Guide Support
C A U T I O N
Porous Pads.
Be careful not to apply too much bond. Do not contaminate the
Front Paper Guide Support Porous Pads with the bond.
The porous pad surface must be lower than the surface of the
Front Paper Guide by 0.5 to 1 mm.
Disassembly
Revision A
0.5 to 1.0 mm
Figure 2-20, and make sure the
53