Epson Stylus Photo R340 Service Manual page 82

EPSON Stylus Photo R340/350
Reinstalling the CSIC Board
Make sure that the CSIC Board is securely fitted onto the
correct position.
Tighten the screws to secure the IC Guide in the order
shown in Figure
Reinstalling the PW Sensor Board
Make sure that the PW Sensor FFC is correctly connected.
Make sure that the PW Sensor Board is properly secured
with the PW Sensor Cap.
Reinstalling the CR Encoder Sensor Board
Make sure that the CR Encoder Sensor FFC is correctly
connected.
Reinstalling the FFC Holder; B
Tighten the screws in the order shown in
Reinstalling the Carriage Unit
Set a portion of the Timing Belt that has serrated surfaces
on both sides into the groove of the Carriage Unit.
Make sure that the Head Grounding Plate is installed at the
correct position on the Carriage Unit.
Timing Belt
Figure 2-73. Head Grounding Plate Installation Position
Disassembly and Assembly
2-72.
Figure 2-71.
Head Grounding Plate
Groove
Reinstalling the Right/Left Scale Holders
Be sure to attach the Scale Holder Sliders to the both left
and right Scale Holders before reinstalling the holders.
Figure 2-74. Reattaching the Scale Holder Sliders
Reinstalling the E Ring
Be sure to attach the E ring with its smoother surface facing
outward.
Disassembly
Right Scale Holder Left Scale Holder
Scale Holder Sliders
Smoother Side Rough Side
Figure 2-75. Attaching the E Ring
Revision A
82