Epson Stylus NX510/515/SX510W/515W/TX550W/NX415/SX410/415/TX410/419/NX215/SX210/215/TX210/213/219/ME OFFICE 510
When installing the Hopper, be sure to engage the rib of the
Hopper with the guide groove of the Base Frame.
Figure 4-46. Installing the Hopper
Whenever the Hopper is removed/replaced, the required
A D J U S T M E N T
R E Q U I R E D
adjustments must be carried out.
•
Chapter 5 " ADJUSTMENT" (p.161)
DISASSEMBLY/ASSEMBLY
Hopper
Rib and Groove
Disassembling the Printer Mechanism
4.5.4 Removing the Printer Mechanism (Lower Housing)
See the following because the disassembling/reassembling
C H E C K
procedures of the Printer Mechanism for SX410/SX210 series
P O I N T
differ from those of NX510 series.
SX410 series:
" 4.7.4 Removing the Printer Mechanism (Lower Housing)
(SX410 series) " (p152)
SX210 series:
" 4.8.4 Removing the Printer Mechanism (Lower Housing)
(SX210 series) " (p160)
Parts/Components need to be removed in advance
Document Cover/ASF Cover/Scanner Unit/Panel Unit/Upper Housing/Card Slot Cover
Removal procedure
1.
Release the Cover Open Sensor cable from the hooks (x2) on the Main Board
Unit.
2.
Disconnect the Panel FFC (CN5) and the Cover Open Sensor cable (CN16)
from the Main Board Unit.
Panel FFC
Cover Open
Sensor cable
CN5
CN16
Main Board Unit
Cover Open Sensor
Figure 4-47. Removing the Printer Mechanism (1)
Revision A
Cover Open Sensor cable
Hook
117
Confidential