Download  Print this page

Advertisement

EPSON Stylus Photo R340/350
Align the Panel FFC and the LCD FFC with the lines marked
on the side of the Main Board Assy., and secure them with two-
sided tape keeping the positions shown in the figure below.
Gap 1 - 2 mm
Figure 2-30. Routing the Panel FFC
Disassembly and Assembly
Line Marked
Gap 1 - 2 mm
Whenever the Main Board Assy. is replaced, be sure to perform the
A D J U S T M E N T
R E Q U I R E D
required adjustments in the order given below. (See Chapter 3 for
details on the adjustments)
When retrieving the ID data from the previous main board is
possible
1.
EEPROM data copy
When the ID data cannot be read out from the previous main
board
1.
Replace the Waste Ink Pad with a new one
(Because the waste ink counter information cannot be
retrieved.)
2.
Market setting
3.
USB ID input
4.
Protection counter
5.
Head Rank ID Label input
6.
First Dot adjustment
7.
PW Sensor adjustment
8.
Head Angle adjustment
9.
Bi-D Adjustment
10. Offset Input for CR Motor Calorific Limitation
Disassembly
Revision A
57

Advertisement

   Related Manuals for Epson Stylus Photo R340

This manual also for:

Stylus photo 350

Comments to this Manuals

Symbols: 0
Latest comments: