Epson Stylus Photo R340 Service Manual page 63

EPSON Stylus Photo R340/350
Illustration (2)
Paper Block
LD Roller Shaft Holder
Positioning Holes
Guide Pins
Spur Gear 36.8
Hooked
Tabs
Clutch Extension Spring 0.143
Acetate Tape
PE Sensor
Connector Cable
PE Sensor
Hooked Tabs
Figure 2-43. Removing the Shaft Assy. Holder (2)
Disassembly and Assembly
LD Roller LD Roller Shaft
Guide Pins
L-shaped Leg Torsion Spring 0.22
2
1
Shaft
Shaft
Straight Leg PE Lever Sensor
Disassembly
Removing the LD Roller Shaft
6. Release the two tabs ( ) that secure the Paper Block and remove it.
7. Release the two tabs ( ) that secure the LD Roller Shaft and remove it
together with the Clutch.
When performing the next step, do not touch the LD Roller with
C A U T I O N
bare hands.
8. Remove the Spur Gear 36.8 from the LD Roller Shaft.
9. Release the Extension Spring 0.143 from the tabs ( ) of the Clutch and the
LD Roller Shaft and remove the spring together with the Clutch.
10. Remove the LD Roller from the LD Roller Shaft.
Removing the PE Sensor
11. Remove the shaft of the PE Sensor Lever from the LD Roller Shaft Holder in
the order shown in Figure 2-43, and remove the PE Sensor Lever and the
Torsion Spring 0.22.
12. Remove the acetate tape that secures the PE Sensor connector cable, and
release the cable from the three tabs ( ) of the LD Roller Shaft Holder.
13. Release the PE Sensor from the tab ( ) and remove the sensor.
Revision A
63