Epson Stylus Photo R340 Service Manual page 64

EPSON Stylus Photo R340/350
Reinstalling the PE Sensor
Route the PE Sensor connector cable as shown in
2-43. Be sure to route the cable under the two ribs of the LD
Roller Shaft Holder.
Figure 2-44. Routing the PE Sensor Connector Cable
Hitch the L-shaped leg of the Torsion Spring 0.22 to the
groove of the PE Sensor Lever, and hitch the other straight
leg to the LD Roller Shaft Holder.
Make sure that the PE Sensor Lever moves smoothly.
Reinstalling the LD Roller
Make sure to match the directions of the triangular arrows
marked on the LD Roller Shaft and the backside of the LD
Roller.
Triangular Arrow on the LD Roller Shaft
Figure 2-45. Reinstalling the LD Roller
Disassembly and Assembly
Figure
Ribs
Triangular Arrow on the LD Roller
Reinstalling the Clutch
Attach the Extension Spring 0.143 to the Clutch in the
correct orientation as shown in the figure below.
OK
Figure 2-46. Reattaching the Extension Spring 0.143
Set the positioning hole of the Clutch onto the guide pin.
Positioning Hole
Make sure that the Clutch mechanism moves smoothly.
Reinstalling the Paper Block
Set the two positioning holes of the Paper Block onto the
shaft.
Disassembly
NG
Figure 2-47. Reinstalling the Clutch
See Figure 2-43.
Revision A
64