Powering Up; Default Display Cycle; Dvs 605 Menu System - Configuration And Adjustments; Menu Navigation Using Front Panel Controls - Extron electronics DVS 605 Series User Manual

Powering Up

When applying power to the DVS 605, the unit undergoes a start-up self-testing sequence
(see image below) and then the LCD displays the default display cycle.

Default Display Cycle

When in use but not in any menu mode, the LCD screen defaults to cycling through
the input and output configuration currently installed. The displayed content may vary,
depending on the input video signal type (see figure 8 for a typical default display cycle).
Apply
Power
Display screen
starts blank.
13 sec.
EXTRON
16 sec.
ELECTRONICS
All input LEDs flash
(red then green).
1 2 3
4 5 PIP
Figure 8.
The default display cycle shows the scaler output rate and refresh rates for the currently
selected input.
DVS 605 Menu System — Configuration and Adjustments
Scaler configuration and adjustments can be performed by using the embedded web pages
(see
of commands (see
Configuration Software
displayed on the LCD screen. These menus are used primarily when the scaler is first set
up. Details of each of the menus are on the following pages after the main flow chart.

Menu Navigation Using Front Panel Controls

Menu button — Press the Menu button to activate menus and scroll through the eight main
menus.
Next button — Press the Next button to move between the submenus of a selected main
menu item.
Adjust ([, {) knobs — In configuration mode, rotate the horizontal Adjust ([) knob
and vertical Adjust ({) knob to scroll through submenu options and to make adjustment
selections (see the flowcharts in this section for explanations of knob adjustments).
Note: Times shown are approximate.
60-1059-xx
EXTRON 11 sec.
FW v1.xx
DVS 605 XX
Last active input
button remains lit.
1
Typical Default Display Cycle
Using the Default Web Pages
SIS Communication and Control
starting on page 61, or the front panel controls and the menus
Default Display Cycle
IN RGBHV
2 sec.
#1 640x480
2 sec.
on page 94), the Extron Simple Instruction Set (SIS)
starting on page 34 ),
2
IN 31.47 kHz
sec.
#1 59.94 Hz
OUTPUT
2 sec.
720p@60
Product
DVS 605 • Operation 13