Table 9: System Information Page Parameters - Hn9200 Info Section - Hughes HN9200 Installation Manual

System Control Center
Table 9: System Information page parameters – HN9200 Info section
Parameter
Site ID
Serial number
Zipcode
Software Date
Software Release
LAN1 IP Address
LAN1 Subnet Mask
LAN1 MAC Address
Figure 64: System Information page
The parameters listed in the HN9200 Info section of the System Information page are explained
in the following table. Other sections of the screen (Transmit Radio Info and Satellite) provide
additional information about the modem installation and the modem software (Software
Configuration).
Identifies the site where the modem is installed.
The modem's serial number. The serial number may be required
for troubleshooting.
ZIP code of the modem site.
Software build date.
Version of the modem's software. This is typically the
factory-installed software version. However, if the NOC downloads
a newer version of Gateway software to the modem, the newer
version number is displayed.
The satellite modem address. The default modem address is
192.168.0.1. A different modem address can be configured.
Range of addresses available to the satellite modem.
MAC address for the satellite modem.
Explanation
HN9200 Satellite Modem Installation Guide
1038622-0001 Revision B
Chapter 6
75