Entering Satellite Parameters (Manual Entry); Figure 19: Verifying The Satellite Parameters Screen - Hughes HN9200 Installation Manual

Commissioning the satellite modem

Entering satellite parameters (manual entry)

Figure 19: Verifying the satellite parameters screen

3. Verify that the displayed information is correct and click Next.
If the parameters are not correct for the installation, click Back to change the satellite
transponder selection.
4. If you plan to use an antenna pointing tool, select DAPT, OPI, or N/A (for none) from the
Antenna Pointing Tool drop-down list.
For Ka-band select DAPT; for Ku-band a DAPT or OPI may be used.
5. Click Next.
This is an alternate method for entering the satellite parameters. You must use this method if
the satellite and transponder for your installation are not listed in the drop-down list in
18: Satellite Parameters screen
Skip this section if you selected a satellite and transponder on the Satellite Parameters screen.
The satellite parameters are provided to you in a technical update email or other communication.
To enter the parameters:
1. On the Satellite Parameters screen, select the Enter satellite parameters manually checkbox
shown in Figure 18: Satellite Parameters screen
2. Click Next.
on page 30 and you were not provided with an sbc.cfg file.
on page 30.
HN9200 Satellite Modem Installation Guide
1038622-0001 Revision B
Chapter 4
Figure
31