Satellite-Based Commissioning; Obtaining An Ip Address From The Satellite Modem - Hughes HN9200 Installation Manual

Chapter 4

Satellite-based commissioning

Obtaining an IP address from the satellite modem

HN9200 Satellite Modem Installation Guide
22
1038622-0001 Revision B
Satellite-based commissioning (SBC) is the preferred commissioning method. Using SBC, you
use a web-based interface on the satellite modem to:
• Obtain an IP address from the modem
• Verify the Ethernet connection (ping test)
• Upload the sbc.cfg file to the modem
• Enter commissioning parameters
• Point the antenna
• Register the modem
The modem contains an SBC configuration file (sbc.cfg) that contains satellite information for
SBC and the auto-commissioning server (ACS) used during commissioning. Occasionally, new
satellites are activated to support broadband service. As a result, you may be required to upload
an sbc.cfg file to the modem prior to installation or manually enter satellite parameters during
modem installation.
If a new sbc.cfg file is available you are instructed to download the sbc.cfg file from an
installation support web site. You must save the sbc.cfg file the installer laptop computer prior
to commissioning so you can upload it to the modem.
If a new satellite is activated but a new sbc.cfg file is not available, the new satellite parameters
are distributed to you in a technical update email or other communication. In this case you must
manually enter the new satellite parameters.
Note: If the service provider has provided you with an sbc.cfg file, you must complete
the procedures in Uploading the sbc.cfg file to the satellite modem
the file to the modem.
If you need troubleshooting information concerning satellite-based commissioning, see the
satellite modem's online Help. Access this information through the System Control Center Help
link (Help → Frequently Asked Questions).
1. Make sure the installer laptop is configured to support DHCP.
2. Verify that the installer laptop is connected to the modem with an Ethernet cable.
3. Open a command prompt or window on the installer laptop.
4. Type ipconfig /release.
5. Press Enter.
6. Type ipconfig /renew.
7. Press Enter.
Note: To view all IP configuration commands, open a command prompt window, type
ipconfig /help, and press Enter.
If the modem does not assign IP address 192.168.0.2 to the installer laptop, restart the installer
laptop to obtain the IP address.
Commissioning the satellite modem
on page 24 to upload