Computer And Networking Requirements; Computer Requirements - Hughes HN9200 Installation Manual

Chapter 2
Table 2: Power supply specifications for the HN9200 satellite modem
Power supply type
AC/DC (64 W)
AC/DC (80 W)
DC/DC (65 W)
All listed power supplies may be used with a 1 W or 2 W Ka-band or Ku-band radio. All have a detachable
power cord.

Computer and networking requirements

Computer requirements

HN9200 Satellite Modem Installation Guide
8
1038622-0001 Revision B
modem, always unplug the AC power cord from the power source (power outlet, power strip,
or surge protector). Do not remove the DC power cord from the modem's rear panel. Doing so
could result in an electrical shock or damage the modem.
When you re-apply power to the modem, plug the AC power cord into the power source.
Part number
1500089-0001
1500185-0001
1033554-0001
This section lists the requirements for the computer or other device, network, and browser to be
used with the satellite modem.
The HN9200 satellite modem can be used with any device that supports IP and has a 10/100
BaseT Ethernet LAN port. Typically, the modem is connected to a customer's computer. However,
the HN9200 is self-hosted; it does not require a computer for any of its functions.
Requirements for the computer to be used with the satellite modem are the same for the laptop
computer you use to install the modem and the customer's computer that will be connected to
the modem. In either case, the computer should meet the minimum requirements specified by
Preparing for installation
If there is any reason to remove power from the satellite
Electrical requirements
Input line voltage:
90 to 264 VAC, 2 A maximum
Input line frequency:
50 to 60 Hz AC
Rated power consumption: 64 W
Input line voltage:
90 to 264 VAC, 2 A maximum
Input line frequency:
50 to 60 Hz AC
Rated power consumption: 80 W
Input line voltage:
12 to 24 VDC, 10 A maximum
Rated power consumption: 65 W