Connecting The Transmit And Receive Cables; Figure 5: Connecting The Transmit And Receive Cables To The Modem - Hughes HN9200 Installation Manual

Installing the satellite modem

Connecting the transmit and receive cables

Figure 4: HN9200 in vertical position
Connect the transmit and receive IFL cables to the satellite modem.
1. Connect the transmit and receive cables to the connectors on the rear panel of the modem as
shown in

Figure 5: Connecting the transmit and receive cables to the modem

Figure 5: Connecting the transmit and receive cables to the modem
tightened.
• Make sure each connector is properly aligned (not cross-threaded).
• The connector should be finger tight with no play.
The transmit and receive cable connectors must be securely
HN9200 Satellite Modem Installation Guide
1038622-0001 Revision B
Chapter 3
on page 15.
15