Uploading The Sbc.cfg File To The Satellite Modem - Hughes HN9200 Installation Manual

Chapter 4

Uploading the sbc.cfg file to the satellite modem

HN9200 Satellite Modem Installation Guide
24
1038622-0001 Revision B
unplugging the power cord from the modem's rear panel. Doing so could result in static
electricity discharge that could shock you and/or damage the modem.
7. Make sure an Ethernet router or switch is not connected to the satellite modem and to the
customer's computer.
8. Try the ping test again.
9. If the ping test is unsuccessful, call Installer Support for assistance.
The sbc.cfg file contains satellite information for SBC and the auto-commissioning server (ACS)
to be used for the commissioning process. Once you have obtained the sbc.cfg file, save it on
the installer laptop computer making sure to note the location where the file is saved.
If you do not need to upload an sbc.cfg file, go to
To upload the sbc.cfg file:
1. Open a browser on the installer laptop.
2. Type http://192.168.0.1/fs/registration/setup.html in the address bar.
3. Press Enter.
The Satellite Setup menu appears.
Commissioning the satellite modem
Do not power cycle the satellite modem by
Entering the antenna location on page 27.