Drive Shaft Installation - Polaris 2013 RANGER RZR S Service Manual

FINAL DRIVE

Drive Shaft Installation

1. Install new spring ring on drive shaft. Apply an anti-
seize compound to splines.
NEW
Spring Ring
Apply
Anti-Seize
2. Align splines of drive shaft with front gearcase and
reinstall the drive shaft. Use a rubber mallet to tap on
the outboard end of the drive shaft if necessary
3. Install drive shaft into the front bearing carrier.
RZR / RZR S
Shown
4. Install the upper ball joint end into the front bearing
carrier.
7.10
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
5. Install the upper pinch bolt and torque to specification.
23 ft-lbs
(31 Nm)
RZR / RZR S
Shown
23 ft-lbs
(31 Nm)
RZR 4
Shown
Ball Joint Pinch Bolts:
23 ft-lbs (31 Nm)
6. Apply grease to drive shaft axle splines.
7. Install front wheel hub assembly, cone washers, and
hand tighten the castle nut. Install washers with
domed side out.
Cone Washers
Wheel
Hub
= T
Out