Brake System Service Notes; Brake Noise Troubleshooting - Polaris 2013 RANGER RZR S Service Manual

BRAKE SYSTEM SERVICE NOTES

Disc brake systems are light weight, low maintenance, and perform well in the conditions this vehicle will routinely
encounter. There are a few things to remember when replacing disc brake pads or performing brake system service to
ensure proper system function and maximum pad service life.
• Optional pads are available to suit conditions in your area. Select a pad to fit riding style and environment.
• DO NOT over-fill the master cylinder fluid reservoir.
• Make sure the brake pedal returns freely and completely.
• Adjust stop pin on front caliper after pad service.
• Check and adjust master cylinder reservoir fluid level after pad service.
• Make sure atmospheric vent on reservoir is unobstructed.
• Test for brake drag after any brake system service and investigate cause if brake drag is evident.
• Make sure caliper moves freely on guide pins (where applicable).
• Inspect caliper piston seals for foreign material that could prevent caliper pistons from returning freely.
• Perform a brake burnishing procedure after installing new pads to maximize service life.
• DO NOT lubricate or clean the brake components with aerosol or petroleum products. Use only approved brake
cleaning products.

BRAKE NOISE TROUBLESHOOTING

Dirt or dust buildup on the brake pads and disc is the most common cause of brake noise (squeal caused by vibration).
If cleaning does not reduce the occurrence of brake noise, Permatex™ Disc Brake Quiet can be applied to the back of
the pads. Follow directions on the package. This will keep pads in contact with caliper piston(s) to reduce the chance
of squeaks caused by dirt or dust.
Possible Cause
Dirt, dust, or imbedded material on pads or disc
Pad(s) dragging on disc (noise or premature pad wear)
because of improper adjustment
Master cylinder reservoir overfilled
Master cylinder compensating port restricted
Master cylinder piston not returning completely
Caliper piston(s) not returning
Operator error (riding the brake)
Loose wheel hub or bearings
Brake disc warped or excessively worn
Brake disc misaligned or loose
Noise is from other source (axle, hub, disc or wheel)
Wrong pad for conditions
Brake Noise Troubleshooting
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
Remedy
Spray disc and pads with CRC Brakeleen™ or an
equivalent non-flammable aerosol brake cleaner. Remove
pads and/or disc hub to clean imbedded material from disc
or pads.
Adjust pad stop (front calipers)

Set to proper level
Clean compensating port
Inspect. Repair as necessary
Clean piston(s) seal 
Educate operator
Check wheel and hub for abnormal movement.
Replace disc
Inspect and repair as necessary
If noise does not change when brake is applied check
other sources. Inspect and repair as necessary
Change to a softer or harder pad
BRAKES
9
9.3