Polaris 2013 RANGER RZR S Service Manual page 291

NOTE: Install the roll cage so that the ring gear
grooves line up with the roll cage slots (see below).
Align during
installation
6. Install the torsion spring by wrapping each leg of the
spring around the dowel pin on the ring gear.
7. Align the spring retainer dowel pin with the ring gear
dowel pin and install the retainer on top of the torsion
spring.
Align during
installation
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
8. Check the action of the torsion spring by rotating in
both directions to ensure the spring and retainer are
installed properly.
9. Be sure the armature plate tabs are fully engaged into
the roll cage assembly and are resting on the cut-
grooves of the ring gear.
Engage
Tabs
NOTE: Verify armature plate tabs are in the slots on
the roll cage and are resting in the ring gear grooves.
10. Carefully install the ring gear and roll cage assembly
into the gearcase housing.
FINAL DRIVE
7
7.23