Polaris 2013 RANGER RZR S Service Manual page 337

Hide thumbs Also See for 2013 RANGER RZR S:

Table of Contents

NOTE: The reverse idler shaft is a non-serviceable

item and should not be pressed out of the housing.

8. Remove the input shaft seal and clutch intermediate

shaft seal using a seal puller or punch.

9. Remove the (2) screws that attach the gear position

sensor to the shift housing. Inspect the O-ring, switch

poles and contact pins for wear or damage. Replace

parts as required.

9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual

10. Remove the spacer, contact pins, springs, drum gear

and washer from the shift housing. Replace any worn

or damaged components.

11. Remove the outer detent screw, spring and ball from

the shift housing.

NOTE: DO NOT remove the detent sleeve assembly

before removing the outer detent screw. Removing

the detent sleeve first will allow the detent ball and

spring to fall into the shift housing.

TRANSMISSION

Chapters

Table of Contents

2013 ranger rzr 4