Table of Contents
Advertisement
10. Install the Drive Clutch Holder (PN 9314177) (A).
11. Remove drive clutch retaining bolt and remove drive
clutch using the Drive Clutch Puller (PA-48595) (B).
Drive Clutch Puller: PA-48595
Drive Clutch Holder: 9314177
12. Remove the (3) screws and (3) bolts that retain the
inner clutch cover to the engine and transmission.
PVT Assembly
1. Inspect inner clutch cover. Replace if cracked or
damaged.
2. Inspect the seal on the transmission input shaft.
Replace if damaged.
A
B
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
3. Apply RTV silicone sealant to the back side of the
inner clutch cover to ensure a water tight fit between
the engine and inner clutch cover. Both surfaces must
be clean to ensure adhesion of silicone sealant.
4. Install and properly align the inner clutch cover.
5. Install the bolts and washers that retain the cover to
the transmission. Torque bolts to specification (see
next page).
6. Install the screws that retain the cover to the engine.
Torque screws to specification (see next page).
Remove any excess silicone sealant.
7.
Install clutch offset washers on the transmission input
shaft.
8. Clean the splines inside the driven clutch and on the
transmission input shaft.
9. Apply a light film of grease to the splines on the shaft.
10. Install the driven clutch, washer, lock washer, and
retaining bolt. Torque to specification (see next page).
11. Clean end of taper on crankshaft and the taper bore
inside drive clutch.
CLUTCHING
6
Offset
Washers
6.7
Advertisement
Chapters
Table of Contents
Troubleshooting
