Engine Oil And Filter Service - Polaris 2013 RANGER RZR S Service Manual

MAINTENANCE

Engine Oil and Filter Service

Always change engine oil and filter at the intervals outlined
in the Periodic Maintenance Chart. Always change the oil
filter whenever changing the engine oil.
Personal injury can occur when handling used
oil. Hot oil can cause burns or skin damage.
Recommended Engine Oil / Filter:
PS-4 Plus Synthetic 4-Cycle Engine Oil
(PN 2876244) (Quart)
Engine Oil Filter (PN 2540086)
Capacity: 2 Quarts (1.9 L)
1. Position vehicle on a level surface.
2. Place the transmission in PARK (P).
3. Start the engine. Allow it to idle for two to three
minutes until warm. Stop the engine.
4. Clean area around oil drain plug at bottom of engine.
NOTE: Drain plug is accessed
Drain Plug
Oil may be hot. Do not allow hot oil to come into
contact with skin, as serious burns may result.
5. Place a drain pan beneath engine crankcase and
remove the drain plug.
2.16
WARNING
=
through the skid plate.
CAUTION
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
6. Allow oil to drain completely.
7. Replace the sealing washer on drain plug.
NOTE: The sealing surface on the drain plug should
be clean and free of burrs, nicks or scratches.
8. Reinstall drain plug and torque to specification.
Crankcase Drain Plug:
16 ft-lbs (22 Nm)
9. Place shop towels beneath oil filter. Using Oil Filter
Wrench (PU-50105) and a 3/8" extension, turn the oil
filter counter-clockwise to remove it.
Oil Filter
Oil Filter Wrench:
PU-50105: 2.5" (64 mm)
10. Using a clean dry cloth, clean filter sealing surface on
the crankcase.
11. Lubricate O-ring on new filter with a film of fresh
engine oil. Check to make sure the O-ring is in good
condition.
12. Install new filter to specification.
Oil Filter:
Turn by hand until filter O-ring contacts
sealing surface, then turn an additional 1/2
= T
= T
turn