Rear Stabilizer Bar (Rzr S / Rzr 4); Removal / Installation - Polaris 2013 RANGER RZR S Service Manual

REAR STABILIZER BAR (RZR S / RZR 4)

Removal / Installation

1. Remove the exhaust pipe and exhaust silencer from
the vehicle.
NOTE: The exhaust silencer can be removed
through the side of the vehicle after the exhaust pipe
is detached from the header pipe.
2. Remove the fastener retaining the stabilizer bar to the
linkage on each side of the vehicle.
Remove
3. Remove the (4) fasteners retaining the stabilizer bar
to the bracket.
4. Remove the stabilizer bar from the bracket (bracket
can remain attached to the frame).
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
BODY / STEERING / SUSPENSION
Leave bracket
attached to frame.
5. Inspect the stabilizer bar for straightness. Inspect the
bushings and replace if needed.
6. Reverse the procedure for installation. Torque the
stabilizer bolts to specification.
Nuts
Grease
Zerk
Bushings
18 ft-lbs
(24 Nm)
Linkage
Stabilizer Mounting Bolts:
18 ft-lbs (24 Nm)
Remove
Fasteners
RZR S Shown
Stabilizer Bar
Bracket
= T
5.45
5