Transmission Shift Housing Reassembly - Polaris 2013 RANGER RZR S Service Manual

TRANSMISSION

Transmission Shift Housing Reassembly

1. Install a new shift cable lever seal and press it flush
with the case. Apply lubricant to the seal lip.
2. Lubricate the shaft of the shifter assembly and install
the assembly into the housing with a new retaining
ring and washer. Install the shift cable lever ("X" facing
out) and torque the retaining screw to specification.
Shift Cable Lever Screw:
15-20 ft-lbs (20 - 27 Nm)
3. Assemble the input shaft with new ball bearings (if
required).
NOTE: Install new bearings and seals by pressing
on the inner race only.
8.16
= T
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
4. Install the input shaft assembly into the transmission
housing.
5. Install the clutch yoke into the shifter assembly. Align
the holes and install clutch yoke pivot pin.
Pivot
Pin
6. Install the pivot pin set screw and torque to
specification.
Shifter
Assembly
Clutch
Yoke