Rear Stabilizer Bar (Rzr); Removal / Installation - Polaris 2013 RANGER RZR S Service Manual

BODY / STEERING / SUSPENSION

REAR STABILIZER BAR (RZR)

Removal / Installation

1. Remove the exhaust pipe and exhaust silencer from
the vehicle.
NOTE: The exhaust silencer can be removed
through the side of the vehicle after the exhaust pipe
is detached from the header pipe.
2. Remove the retaining nut from the upper portion of the
stabilizer bar linkage bushing on each side of the
vehicle.
Remove Nut
3. Remove the (4) fasteners retaining the stabilizer bar
bracket to the frame.
4. Remove the stabilizer bar and bracket from the frame
as an assembly.
5.44
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
5. Inspect the stabilizer bar for straightness. Inspect the
bushings and replace if needed.
6. Inspect the rubber bushings on the linkage rod and
replace if needed.
7. Reverse the procedure for installation. Torque the
stabilizer bolts to specification.
17 ft-lbs
(23 Nm)
Bushing
Bushing
Grease
Zerk
Linkage
Bushing
Stabilizer Mounting Bolts:
18 ft-lbs (24 Nm)
Remove
Fasteners
Stabilizer Bar
Linkage
18 ft-lbs
(24 Nm)
Bracket
17 ft-lbs
(23 Nm)
= T