Tail / Brake Lights; Bulb Replacement - Polaris 2013 RANGER RZR S Service Manual

TAIL / BRAKE LIGHTS

Bulb Replacement

Before replacing the bulb(s), use a digital multi-meter to
test the harness to ensure the lamp is receiving 12 volts
and that a ground path is present.
If a tail light, brake light or turn signal (INT'L Only) does not
work the bulb may need to be replaced.
1. Disconnect the wire harness.
2. Remove bulb by turning the rubber base 1/4 turn and
pulling the bulb out. Replace it with recommended
bulb. Apply Dielectric Grease (PN 2871329).
Tail / Brake
INT'L
Tail / Brake
Models
Turn Signal
Light
3. Connect the wire harness.
4. Test the tail light, brake light and turn signal (INT'L
Only) to verify it is working properly.
Light
Light
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
ELECTRICAL
10
10.21