Outer Cv Joint / Boot Replacement - Polaris 2013 RANGER RZR S Service Manual

FINAL DRIVE
6. Remove the bolt that attaches the rear bearing carrier
to the upper A-arm.
7. Slide the rear drive shaft out of the bearing carrier by
pulling the bearing carrier assembly outward and
tipping it down to remove the shaft.
8. Grasp the rear drive shaft and pull sharply outward on
the shaft to disengage it from the rear gearcase.
NOTE: Take care when
damaging the seal.
9. Inspect axle splines and CV boots for any damage.
7.30
removing to prevent
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.

Outer CV Joint / Boot Replacement

1. Use a side cutters to cut and discard the boot clamps.
2. Remove the large end of the boot from the CV joint
and slide the boot down the shaft.
3. Clean the grease from the face of the joint.
4. Place the drive shaft in a soft-jawed vise. Using a soft-
faced hammer, or brass drift, strike the inner race of
the joint to drive the joint off the drive shaft. Be sure
to tap evenly around the joint to avoid binding.
IMPORTANT: Tap on inner race only!
Brass Drift Shown