Polaris 2013 RANGER RZR S Service Manual page 338

TRANSMISSION
12. Pull back fully on gear selector arm to bring shift collar
up and disengage the shift collar from the clutch yoke.
Lifting on the clutch shaft may aid in shift collar
removal.
13. Inspect the inner and outer gear teeth and splines on
both ends of the shift collar for excessive wear or
damage.
14. Remove the retaining rings from each end of the shift
collar.
15. Remove the wave spring and ball bearing cage
assembly from the shift collar as shown.
IMPORTANT: Wave spring
end of shift collar must face
out toward the park flange
when installed on the
intermediate shaft asm.
16. Inspect the ball bearing channels on both ends of the
shift collar for excessive wear or damage.
17. Remove the sliding shoes from the clutch yoke.
8.14
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
18. Remove the clutch shaft assembly from the housing.
The forward gear assembly and bearings will remain
on the shaft upon removal.
19. Disassemble the clutch shaft as needed by removing
both retaining rings and separating the high and low
gears from the clutch shaft. Inspect all parts for wear
or damage and replace as required.
20. Remove the set screw retaining the pivot pin.