Polaris 2013 RANGER RZR S Service Manual page 343

17. Install the reverse clutch assembly onto the park
flange. Note the orientation of the needle bearing.
18. Install the retaining plate and a new retaining ring.
19. Install the input shaft seal and verify it is fully seated.
Install the intermediate shaft seal (circled) flush or
slightly below the case. Apply lubricant to both seal
lips.
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
20. Place the transmission shift housing onto a flat
surface as shown. Apply a bead of crankcase sealant
onto the mating surfaces. Align the dowels and install
the transmission case half onto the shift housing while
rotating the input shaft, using care not to damage the
seal surfaces.
Apply Sealant: PN 2871557
to Case Mating Surfaces
21. Install the shift cable bracket and (7) shift housing
case screws to the front of the transmission. Torque
to specification.
Shift Housing Screws:
23-27 ft-lbs (31-37 Nm)
TRANSMISSION
2871557
= T
8.19
8