Polaris 2013 RANGER RZR S Service Manual page 339

21. Locate the retaining ring on the shifter assembly and
move the retaining ring out of the groove to allow the
shifter assembly to slide out.
Pivot
Pin
Clutch
22. Use a needle nose pliers to grab the pivot pin and slide
the pin out of the case.
23. Remove the clutch yoke from the shifter assembly and
out from the transmission housing.
24. Remove the transmission input shaft from the
housing. Inspect the shaft bearing and replace if
required using a shop press. Inspect the gears for
damage and/or wear. Replace the shaft if required.
Shifter
Assembly
Yoke
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
25. Remove the screw from the end of the shift cable lever
and remove the shifter assembly from the housing.
26. Inspect the shifter assembly shaft and housing for
excessive wear or damage. Replace components if
needed.
27. Inspect and replace the case bearings if required.
NOTE: Do not pull
inspection, as the removal process damages the
bearing.
TRANSMISSION
bearings from case
8.15
for
8