Bearing Carrier Installation - Polaris 2013 RANGER RZR S Service Manual

FINAL DRIVE

Bearing Carrier Installation

1. Install drive shaft axle through the backside of the
bearing carrier. Be sure bushings and pivot tubes are
installed.
2. Install the fasteners that attach the rear bearing carrier
to the upper and lower A-arms. Torque bolts to
specification.
Upper Rear Bearing Carrier Bolts:
RZR: 33 ft-lbs (45 Nm)
RZR S / RZR 4: 40 ft-lbs (54 Nm)
Lower Rear Bearing Carrier Bolts:
RZR: 38 ft-lbs (52 Nm)
RZR S / RZR 4: 40 ft-lbs (54 Nm)
3. Apply grease to drive shaft axle splines.
7.28
= T
= T
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
4. Install rear wheel hub assembly, cone washers, and
hand tighten the castle nut. Install washers with
domed side out.
Cone Washers
Wheel
Hub
5. Install brake caliper mounting bolts and torque to 18
ft-lbs (24 Nm).
Rear Caliper Mounting Bolts:
18 ft-lbs (24 Nm)
New bolts have a pre-applied locking agent
which is destroyed upon removal. Always use
new brake caliper mounting bolts
upon assembly.
Out
18 ft-lbs
24 (Nm)
= T
CAUTION