Bearing Carrier Installation - Polaris 2013 RANGER RZR S Service Manual

FINAL DRIVE
Bearing Installation
5. Thoroughly clean the front bearing carrier housing
and the outer race on the new bearing. Be sure that
all oil residue has been removed from each surface.
6. Support the bottom of the bearing carrier housing.
Use an arbor and press only on the outer race,
otherwise bearing damage may occur.
7. Apply Loctite® 603™ retaining compound to outer
circumference of new bearing race and carefully
press new bearing into the bearing carrier housing.
Apply
Loctite® 603™
Snap Ring
RZR / RZR S
Shown
NOTE: Use care to not allow any of the Loctite®
compound to get in the bearing.
8. Wipe the housing clean of any excess compound and
install the snap ring.

Bearing Carrier Installation

1. Install drive shaft axle through the backside of the
bearing carrier.
2. Install the upper and lower ball joint ends into the front
bearing carrier.
RZR / RZR S
Shown
7.4
CAUTION
Bearing
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
3. Install pinch bolts and torque to specification.
23 ft-lbs
(31 Nm)
RZR / RZR S
Shown
23 ft-lbs
(31 Nm)
RZR 4
Shown
Ball Joint Pinch Bolts:
23 ft-lbs (31 Nm)
4. Apply grease to drive shaft axle splines.
5. Install front wheel hub assembly, cone washers, and
hand tighten the castle nut. Install washers with
domed side out.
Cone Washers
Wheel
Hub
= T
Out