Rear Stabilizer Bar / Linkage; Removal / Installation - Polaris RANGER ETX 2015 Owner's Manual

REAR STABILIZER BAR / LINKAGE

REMOVAL / INSTALLATION

1. Elevate and safely support vehicle with weight
removed from the rear wheel(s).
2. Remove the retaining nut
of the stabilizer bar linkage bushing on each side of
the vehicle.
3. Remove the two fasteners
stabilizer bar to the main frame on each side.
4. Remove the stabilizer bar from the frame and inspect
the stabilizer bar for straightness.
5. Inspect the stabilizer bar bushings and replace if
needed.
6. Inspect the rubber bushings on the stabilizer linkage
rod and replace if needed. If replacing the stabilizer
linkage, remove the lower shock bolt from the upper
A-arm.
7. Reverse this procedure for installation.
8. Torque the stabilizer retaining bolts and upper rubber
bushing nuts to specification.
9. If the stabilizer linkage was removed, torque the
lower shock retaining bolt to specification.
9926806 R03 - 2015 - 2016 RANGER ETX / 570 2-SEAT 2015 - 2016 RANGER 570 CREW Service Manual
© Copyright Polaris Industries Inc.
q
from the upper portion
w
that secure the
STEERING / SUSPENSION
ASSEMBLY VIEW
REF. DESCRIPTION
q Lower A-Arm
w Stabilizer Bar
Linkage
e Stabilizer Bar
r Stabilizer Bar
Bushing / Shield
t Nut
NOTES
Torque to 17 ft-lbs
(23 Nm)
8
8.19