Rear Stabilizer Bar (Rzr S / Rzr 4) - Polaris 2011 RANGER RZR Service Manual

BODY / STEERING / SUSPENSION

REAR STABILIZER BAR (RZR S / RZR 4)

Removal / Installation
1. Remove the exhaust pipe and exhaust silencer from the
vehicle.
NOTE: The exhaust silencer can be removed
through the side of the vehicle after the exhaust pipe
is detached from the header pipe.
2. Remove the fastener retaining the stabilizer bar to the
linkage on each side of the vehicle.
Remove
3. Remove the (4) fasteners retaining the stabilizer bar to the
bracket.
5.40
9923142 - 2011 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2010 Polaris Sales Inc.
4. Remove the stabilizer bar from the bracket (bracket can
remain attached to the frame).
Leave bracket
attached to frame.
5. Inspect the stabilizer bar for straightness. Inspect the
bushings and replace if needed.
6. Reverse the procedure for installation. Torque the stabilizer
bolts to 18 ft. lbs. (24 Nm).
Nuts
Grease
Zerk
Bushings
18 ft. lbs.
Linkage
Remove
Fasteners
RZR S Shown
Stabilizer Bar
Bracket
(24 Nm)